0 $0.00


Textured Rubber grip sets available for most handgun pistols.  The grips wrap around the front of the pistol, covering the front and both sides.  There is also a strip included to fit the bottom of the trigger guard.  There are small cut-out fillers on the front side, which can be left off to use with finger groove frames.

Grit (sand texture) grip sets are also available, but have right and left panels, which don’t cover the front.

   This product fit the gun perfectly and did not have any cosmetic flaws. The rubber compound gives me a very good grip on the gun without adding bulk like the rubber sleeve grip adapters. Use the blow dryer to heat the gun grip surface well before installing the grip, it really helps mesh it with the existing grip texturing. There is no back-strap cover piece, which is fine with me because I would not have installed it anyway. Don’t need the added thickness between the front and back of the grips, and the guns back-strap checkering is more than enough for a good grip. Its hard to tell that the grip overlay is not part of the gun itself. The price was very good and it was delivered very quickly. Took about 15 minutes to install. No trimming/cutting involved.

We also have Grips Available for those handguns:

 Grips for Walther PPX in 9mm or .40

 Grips for 3rd Gen Glock 19, 23, 32, 38,

 Grip for Smith Wesson M&P Shield 9mm, .40

 Grip for Gen4 GLock 17,22,31,34,35,37

 Grip for Springfield XDS 9mm, .45

 Grip for H&K USP 9mm, ,40

 Grip for gen4 GLock 19,23,32,38

 Grip for Glock 42

 Grip for Ruger LC9 LC380

 Grip for Beretta NANO pistol

 Grip for Ar-15 A-2 Style